ASEM ETA_SERIES LABORATORY TABLE

Compliant and certified EN 13150 by Bureau Veritas and tested by CATAS®, as well as their design and production system ISO 9001:2015.



The supporting structure with "C" shaped legs made of 2 mm thick descaled steel tubing in 60x30 and 60x60 mm sections, coated with epoxy powders (thickness 100±10 microns), Pure White RAL 9010 color (other colors available upon request), followed by a thermal chamber treatment at 180 °C. Levelling feet made of steel, coated with acid-resistant plastic material.

The "C" configuration of the base legs allows maximum operator movement freedom, without the frame legs being in the front position.

The frame base with standard wall depth is set back to allow wall attachment in the presence of skirting boards and for positioning after the preparation of the power supply and drainage on the wall.

The worktop is made of laminated plastic, with a moisture-resistant chipboard core, covered on both sides with flame-retardant melamine laminate, Class 1, with a scratch-resistant quartz finish, composed of kraft paper sheets impregnated with phenolic resin, a top decorative sheet in LIGHT GREY impregnated with melamine resin, subjected to combined pressure (90 kg/sqm) and heat (150°), in special presses where resin polycondensation occurs. Formaldehyde content complies with Class 1 according to EN120. The surface offers decent resistance to acids and weak bases. Edge banding in impact-resistant ABS, 3 mm thick and rounded. Total thickness 30 mm.

Levelling feet in steel coated with acid-resistant plastic material.

Available in widths of 60, 90, 120, 150, 180 and with standard depth of 750 or reduced depth of 600, also available in two heights: 770 or 900.